Advertisement
Advertisement
Table of Contents
Related Manuals for EF EFCH6301 HM SS
Summary of Contents for EF EFCH6301 HM SS
- Page 1 EFCH9301 HM SS 15 K i an Teck Crescent Singapore 628884 For original parts & reliable service : Casa(S)Pte Ltd Kian Teck Crescent Singapore 628884 For after sales service support,please contact our hotline: + 65 6268 0077 casa.com.sg Or email us at service@ c asa.com.sg...
-
Page 2: Table Of Contents
Schematic Diagram Table of Contents 1 motor version: • From the Manufacturer • Specifications • SAFETY : Read this first ! 4, 5 • Vent System Requirement • Description of Parts • Ducted vs. Re-circulating modes • Installation 8, 9, 10 •... -
Page 3: From The Manufacturer
Troubleshooting • From the Manufacturer • This appliance and it’s packaging are produced by processes that minimize waste and respect the Symptoms Possible Cause Action environment. Check that the plug • Please help us to continue the protection of the Does not function No electrical supply is connected. -
Page 4: Safety : Read This First
SAFETY : Read this First ! Cleaning & Maintenance • Do not connect the appliance if there are obvious signs of transportation SURFACES : Wash with warm soapy water and a soft sponge. Never use damage. abrasive detergent, scouring pads, steel wool or solvents on any part of this •... -
Page 5: Vent System Requirement
Operation SAFETY : Read this First ! (Continued) Service agent or similarly qualified persons in order to avoid a hazard. The hood is equipped with 3 speed control. • There shall be adequate ventilation of the room when the range hood is used at the Use the low speed for simmering, medium speed for light cooking. -
Page 6: Description Of Parts
Electrical Connection Description of Parts Before completing any connection, make sure the house voltage corresponds with the voltage indicated on the label affixed inside the hood. It is advisable to call a qualified technician to make the electrical connection. Appliance fitted with plug Connect it to a socket which conforms with current regulations. -
Page 7: Ducted Vs. Re-Circulating Modes
Ducted vs. Re-circulating modes Installation (2) Your cooker hood can be configured to operate in the ducted or re-circulating STEP 1 : Remove the aluminum filters and place them in a safe location to avoid mode. damage. STEP 2 : Hang the hoods first and then Install the 2 screws in the wall through the inside of the hoods like below picture showed. - Page 8 Installation (1) Installation (1) (Continued) STEP 1 : Remove the aluminum filters and place them in a safe location to STEP 3 : Hang the hood on the 2 screws. avoid damage. STEP 4 : Tighten the 2 screws completely. STEP 2 : Install the 2 screws on the wall.
Need help?
Do you have a question about the EFCH6301 HM SS and is the answer not in the manual?
Questions and answers