Symbology Settings Table - CipherLab CP30 Reference Manual

Timeout between same
symbols

SYMBOLOGY SETTINGS TABLE

Laser Engine
Code 11
Check digit verification Decide whether to verify the check digit. If the check digit
Transmit Check Digit
Select Length
Codabar
CLSI editing
NOTIS editing
Select Length
(min/max)
Code 128
GS1-128
(UCC/EAN-128)
ISBT 128
Industrial 25 (Discrete 25)
Select Length
(min/max)
When in Continuous mode, set the minimum time that
must stop detect before the scan engine decodes a second
same barcode. This reduces the risk of accidentally
scanning the same barcode twice.
0.0~9.9 (second)
Description
is incorrect, the barcode will not be accepted.
Disable
One Check Digit
Two Check Digits
Decide whether to include the check digit in the data being
transmitted.
"Check digit verification" must be enabled.
One or two fixed lengths
Range (1~55)
When applied, the CLSI editing strips the start/stop
characters and inserts a space after the first, fifth, and
tenth characters of a 14-character Codabar barcode.
The 14-character barcode length does not include
start/stop characters.
Decide whether to include the start/stop characters in the
data being transmitted.
NOTIS Editing is to strip the start/stop characters, i.e.
to disable "Transmit Start/Stop Characters".
One or two fixed lengths
Range (1~55)
Read GS1-128 barcodes with leading FNC1 character.
Read ISBT 128 barcodes.
One or two fixed lengths
Range (1~55)
Appendix II Laser (SE955)
1.0 sec.
Default
Enable
Disable
No
4~55
Enable
No
No
4~55
Enable
Enable
Enable
Enable
4~55
151