7.2 BARCODE READER SETTINGS
The barcode reader configurations depend on the scan engine(s) installed. You can detect
which barcode type for scan currently in use and make necessary settings on the General
tab.
Barcode Reader
Laser Reader
2D Reader
Decode Session Timeout
Redundancy Level
Scan Angle
Scan mode
Timeout between symbols Only available for Continuous mode. The default value is 1 sec.
Description
If installed, tap the [Barcode Reader] button to configure the reader
settings for CCD or Laser scan engine.
Refer to the Reader Settings Table in Appendix II - Laser (SE955).
The 2D scan engine is capable of reading linear and 2D barcodes.
If installed, tap the [Barcode Reader] button to configure the reader
settings for 2D scan engine.
Refer to the Reader Settings Table in Appendix III - 2D Imager.
The value (from 1 to 9 sec) sets the maximum time decode processing
continues during a decode attempt. The default value is 3 sec.
Refer to Appendix II - Laser (SE955).
Select the scan angle for Long Range Laser scan engine.
Supports Continuous and Laser Modes for selection.
Chapter 7
Using Reader Configuration Utility
101