Symbology Settings Table - CipherLab 8000 Series User Manual

SYMBOLOGY SETTINGS TABLE

CCD/Laser
Codabar
Select Start/Stop
Characters
Transmit Start/Stop
Characters
Code 128
GS1-128
Transmit Code ID
Field Separator
Industrial 25 (= Discrete 25)
Start/Stop Selection
Verify Checksum
Transmit Checksum
Select Length
Interleaved 25
Start/Stop Selection
Verify Checksum
Transmit Checksum
Select Length
Matrix 25
Start/Stop Selection
Description
If "Transmit Start/Stop Characters" is desired, select one
set:
abcd / abcd
abcd / tn*e
ABCD / ABCD
ABCD / TN*E
Decide whether to include the start/stop characters in the
data being transmitted.
Decide whether to include Code ID ("]C1") will be included
in the data being transmitted.
Decide whether to replace the field separator. For
example, type the desired character ";" (semicolon) as the
new field separator.
This decides the readability of all 2 of 5 symbology
variants. For example, flight tickets actually use an
Industrial 2 of 5 barcode but with Interleaved 2 of 5
start/stop pattern. In order to read this barcode, the
start/stop pattern selection parameter of Industrial 2 of 5
should set to "Interleaved 25".
Decide whether to verify the checksum. If the checksum is
incorrect, the barcode will not be accepted.
Decide whether to include the checksum in the data being
transmitted.
One or two fixed lengths
Range
Refer to Industrial 25.
Decide whether to verify the checksum. If the checksum is
incorrect, the barcode will not be accepted.
Decide whether to include the checksum in the data being
transmitted.
One or two fixed lengths
Range
Refer to Industrial 25.
Appendix II CCD/Laser Scan Engine
Default
Enable
abcd/abcd
No
Enable
Enable
No
No
Enable
Industrial 25
No
Yes
4~127
Enable
Interleaved
25
No
Yes
4~127
Enable
Matrix 25
101