Korg STAGE VINTAGE SV-1 User Manual page 39

NOTE: Extreme DRIVE settings may cause unwanted distortion. If this happens,
lower its setting.
AMP MODEL type
Amp1 (Clean Combo)
Amp2 (California)
Amp3 (Tweed)
Amp4 (AC30)
Amp5 (Modded OD)
Organ Amp (Korg OD/HG)
5. Use the TYPE knob of the MODULATION FX section to select a different
modulating effect (chorus, phaser, flanger or rotary speaker). If the rotary
effect is selected, use the SLOW/FAST button to change the rotor's speed.
You can change the speed of the modulation (or horn rotation) by using the
SPEED knob, and the intensity (or horn acceleration) by using the INTENSITY
knob. To return to the default settings, press the SPEED or INTENSITY knob.
HINT: If you select the rotary effect, and a footswitch pedal is connected to the
PEDAL 1 jack on the back of the instrument, you can use the pedal to switch the
rotor speed between the SLOW and FAST settings.
MODULATION FX type
Chorus 1
Chorus 2
Phaser 1
Phaser 2
Flanger
Rotary
Use the TYPE knob of the REVERB/DELAY section to select a different
6.
reverb, echo or delay effect.
If the stereo delay effect is selected, input its time by "tapping" it four times on the
TAP button. The LED flashes at tempo, so that you can understand visually if the
tempo is right. If the tempo was not entered correctly, the LED does not flash.
You can change the intensity of the effect by using the DEPTH knob. To
return to the default setting, press the DEPTH knob.
REVERB/DELAY type
Room
Plate
Hall
Spring
Tape Echo
St. Delay
Using the SV-1 | Selecting and editing the effects – 25
SPEED knob
Speed
Speed
Speed
Speed
Speed
Horn Speed
DRIVE knob
PreVol
PreVol
PreVol
PreVol
PreVol
Drive
INTENSITY knob
Depth
Intensity
Depth
Color (type 1, 2)
Depth
Horn Accel
DEPTH knob
Mix
Mix
Mix
Mix
Mix
Mix