Rear Panel - Korg STAGE VINTAGE SV-1 User Manual

R
EAR PANEL
The back panel is where you can find most of the connections.
1
3 4
POWER connector
1
Connect the included IEC power cable here.
MUSIC STAND holes
2
A music stand comes standard with your SV-1. Insert its legs into these two ded-
icated holes.
USB DEVICE connector
3
Use this connector to connect a computer for sequencing (this doubles the MIDI
ports), or for using the SV-1 Editor software for fine editing. Before using this
connector, please install the KORG USB-MIDI Driver (the relevant instructions
are provided together with the MIDI Driver on the Accessory Disk, or can be
downloaded from our web site).
PEDAL jacks (DAMPER, 1, 2)
4
Connect the supplied Korg DS2H pedal to the DAMPER jack. Connect a foot-
switch to PEDAL 1 and either a footswitch or an expression pedal to PEDAL 2.
DAMPER always operates as a damper pedal. Use it to connect the supplied Korg
DS-2H damper pedal.
Controls and connections | Rear panel – 15
2
0.771°
5 6 7