Kyocera Printserver Installation Manual page 132

Printing via the LPD Protocol
Installation Entries
Requirements
Procedure
4-12
a logical printer into the '/etc/qconfig' file. In this section,
installation by means of the SMIT Administration Tool is
described.
The installation sequence requires the following entries:
Box in SMIT
Name of QUEUE to <arbitrary name> of print queue
add
HOSTNAME of <host name or IP address> of print server
remote server
Name of QUEUE of lp1 to lp8 for the logical printer
remote server
Before installation, make sure that:
! The IP address has been saved in the print server.
! The host name has been assigned to the IP address.
! The print server is connected, and the printer is turned on.
Proceed as follows:
1. Log on as root.
2. Start SMIT.
3. Select the following menu commands in the order shown
below:
'Devices'
'Printer/Plotter'
'Print Spooling'
'Add a Print Queue'
'Other'
4. Enter the following parameters into the screen mask:
[TOP]
*Name of QUEUE to add
*Name of QUEUE DEVICE to add
User input
[MY_QUEUE]
[MY_QUEUE]
Print Server Installation Manual
Example
in text
MY_QUEUE
SB0001FF
lp1