Konica Minolta Magicolor 5430 DL User Manual page 117

Symptom
Printing
takes too
much time.
Blank pages
come out
during print-
ing.
Printer
returned to
READY
before the
menu was
changed.
Not all pages
print.
Solving Other Problems
Cause
The printer is set to a
slow printing mode
(for example, thick
stock or transpar-
ency).
The printer is set to
power saving mode.
The job is very com-
plex.
The printer memory is
insufficient.
A toner cartridge for a
different region or a
non-genuine toner
cartridge is installed
(
NO GENUINE
is dis-
TONER X
played in the mes-
sage window).
One or more of the
toner cartridges are
defective or empty.
The wrong media is
being used.
The printer was in the
menu structure with-
out a selection being
made within two min-
utes.
The printer has the
wrong kind of cable,
or the printer is not
configured for the
correct cable and
port.
The Cancel key was
pressed.
Solution
It takes more time to print with special
media. When using regular paper,
make sure that the media type is set
properly in the driver.
It takes time for printing to start in
power saving mode. If you do not want
to use this mode, disable it.
Wait. No action needed.
Add more memory.
Install a genuine KONICA MINOLTA
toner cartridge approved for your spe-
cific printer.
Check the toner cartridges. The image
will not be printed if the cartridges are
empty.
Check that the media type set in the
driver matches the media loaded in the
printer.
When in the menu structure, select
your choice within 2 minutes.
Check your cable.
Make sure no one pressed the Cancel
key while your job was printing.
109