Updating Your Compresshd Firmware; Note About Using Sleep And Hibernation Modes With Compresshd; Removing Your Matrox Compresshd Software - Matrox CompressHD Installation And User Manual

Hide thumbs Also See for CompressHD:

Table of Contents

Updating your CompressHD firmware

When you install Matrox Mtx.utils on a computer that has the CompressHD card

installed, the Mtx.utils Setup program automatically verifies the firmware on

your CompressHD card and updates it if required. If you install Mtx.utils on a

computer without the CompressHD card, the next time you start your computer

with CompressHD installed, Mtx.utils Setup will update your CompressHD

card's firmware if needed.

²Caution

during the update process. Doing so may damage your CompressHD card.

Note about using sleep and hibernation modes

with CompressHD

Before setting your computer to sleep or hibernation mode, make sure that you

first quit any application that is using your CompressHD hardware, such as

Adobe Media Encoder.

To remove Matrox Mtx.utils from your computer, choose Start > All Programs

> Matrox Mtx.utils > Uninstall Matrox Mtx.utils

Chapter 2, Installing Your Matrox CompressHD Hardware and Software

Do not power off your computer, or interrupt the firmware update

Table of Contents