Updating Your Compresshd Firmware; Note About Using Sleep And Hibernation Modes With Compresshd; Removing Your Matrox Compresshd Software - Matrox CompressHD Installation And User Manual

8

Updating your CompressHD firmware

When you install Matrox Mtx.utils on a computer that has the CompressHD card
installed, the Mtx.utils Setup program automatically verifies the firmware on
your CompressHD card and updates it if required. If you install Mtx.utils on a
computer without the CompressHD card, the next time you start your computer
with CompressHD installed, Mtx.utils Setup will update your CompressHD
card's firmware if needed.
In some cases, you may be asked by Matrox Customer Support to manually run
the Matrox Firmware Updater by choosing Start > All Programs > Matrox
Mtx.utils > Matrox Firmware Updater
Note about using sleep and hibernation modes
with CompressHD
Matrox CompressHD does not support setting your computer to sleep mode
(Vista) or standby mode (XP). Hibernation mode is supported, but before setting
your computer to hibernation mode, make sure that you first quit any application
that is using your CompressHD hardware, such as Adobe Media Encoder.

Removing your Matrox CompressHD software

To remove Matrox Mtx.utils from your computer, choose Start > All Programs
> Matrox Mtx.utils > Uninstall Matrox Mtx.utils
Chapter 2, Installing Your Matrox CompressHD Hardware and Software
.
.