Photovu/Mpeg4 Movie Messenger System (I.link); Using Tape Image Data - Panasonic MultiCam PV-DV202-K Operating Instructions Manual

PHOTOVU/MPEG4 Movie Messenger System (i.LINK)

Using Tape Image Data

By connecting the Palmcorder and PC with
the DV Interface Cable (i.LINK), you can
transfer Motion images and Still images
saved on the DV Tape directly to your PC.
Note
• If PHOTOVU/MPEG4 Movie Messenger
System does not work, please refer to
note on page 74.
• Deactivate your PC ScreenSaver or
this application may shutdown during
image capture.
3
Normal
2
STOP
PLAY
How to insert the DV Interface
Cable (i.LINK)
A
Set Palmcorder POWER to VCR.
B
Connect the Palmcorder to your PC
using the DV Interface Cable
(i.LINK).
C
Start up the PHOTOVU/MPEG4
Movie Messenger System.
How to remove the USB Cable
or DV Interface Cable (i.LINK)
A
Close the PHOTOVU/MPEG4 Movie
Messenger System.
B
Remove the DV Interface Cable
(i.LINK) from the Palmcorder.
C
Set Palmcorder POWER to OFF.
DV202_402-K.p 74-76.p65
Before you begin
• Insert a recorded Tape. (p. 11)
• Make Palmcorder-PC connections.
(p. 74)
• Turn your PC on.
• Set Palmcorder POWER to VCR.
• Run the Software after the DV
Interface Cable (i.LINK) has been
connected to the Palmcorder.
1
Repeat steps 1~4 on page 62 to
run the PHOTOVU/MPEG4 Movie
Messenger System.
Note
• When the DV Interface Cable (i.LINK)
is connected, the input display will
4 automatically become DV. If it is not
Movie
DV, please confirm the connection.
Capture
Then, close and restart the software.
• When using Windows XP, "Windows
Movie Maker" may open
automatically. If so, close "Windows
Movie Maker" and "Movie
Messenger", and open "Movie
DV
Messenger" again.
2
Click
to playback the DV tape.
• Please use the LCD monitor on the
Palmcorder or PC screen for
confirmation.
To capture Motion images
[When selecting Normal]
3
Click on [Normal] .
4
Click on [Movie Capture] at the
point you wish to capture a Motion
image. Click on [STOP] to end capture.
• The image is transferred to the PC in
real time.
• The maximum capture time is approx.
3 minutes.
• When capturing data containing
changes between 12 bit and 16 bit
and/or between SP and LP mode, a
separate file will be made for each
mode.
• Please refer to pages 64~73 for other
functions.
75
(PLAY) button on PC screen
(Continued on next page.)
75
2003/06/12, 10:15