Panasonic MultiCam PV-DV202-K Operating Instructions Manual page 58

Transferring Your Images (Windows)
Notes on PHOTOVU/MPEG4 Movie Messenger System operation
• For PHOTOVU/MPEG4 Movie Messenger System, do not connect the i.LINK and
USB terminals to the Palmcorder at the same time.
• Make sure Palmcorder power is not shut off during use as your PC system may become
unstable. Therefore, the AC Adaptor should be used as the power source. (Be
especially careful when recording in M-CARD or CAMERA mode as the power
eventually shuts off automatically if a tape is inserted.)
• For PHOTOVU/MPEG4 Movie Messenger System, if the play, stop, fast forward,
and rewind functions are operated using the Palmcorder buttons, the image may not be
captured properly. Use Palmcorder Operation Buttons displayed on the PC screen.
Verifying the driver (Windows 98SE/Me/2000/XP)
Note
• Verify the driver while Palmcoder is connected to the computer.
PHOTOVU/MPEG4 Movie Messenger System (VCR Mode)
[ This screen is an example (Windows 2000) ]
Palmcorder USB Device Driver/Web Camera (CAMERA Mode)
[ This screen is an example (Windows 2000) ]
58
DV202_402-K.p 56-61.p65
1
Click "Start," "Settings," and
"Control Panel."
2
Double-click on "System", verify
[Panasonic Digital Palmcorder] is
displayed in [Universal Serial Bus
controllers] of [Device Manager].
1
Click "Start," "Settings," and
"Control Panel."
2
Double-click on "System", verify
[USB Video Camera for Panasonic
Digital Palmcorder] is displayed in
[Imaging Device] of [Device
Manager].
58 2003/06/12, 10:15