Installation In Garages; Pre-Installation Survey; Tube Kit Matrix; Mounting Clearances - Schwank STR Series Installation & Owner's Manual

Gas fired low intensity, tube-type infra red heaters
Table of Contents

Advertisement

2. INSTALLATION IN GARAGES

Schwank STR Series tube heaters are
approved for use in garages. The installation
must conform to local building codes or, in
the absence of local codes, to the standard
NFPA No. 54 (ANSI Z223.1 latest edition),
in the U.S.A. and the CSA B149.1-00, and
CAN1.2.16-M81 in Canada.

3. PRE-INSTALLATION SURVEY

The Schwank STR heating system must
have
gas
piping
length, and arrangement to function properly.
For this reason, a layout drawing is
necessary.
STR HEATER KIT
ASSEMBLY CHART
HEATER MODEL
STR 45 10
STR 45 20
STR 60 20
STR 60 30
Stand-Alone Tube Kits require no additional tube kits.
Primary Tube Kits require at least one additional Secondary Tube Kit.
Secondary Tube Kits require a Primary Tube Kit.
Secondary Tube Kit TS-1010-AX can also be used as a 10 ft extension kit. The installer
may
need to remove the turbulator (refer to Turbulator Chart in the I&O Manual).

4. MOUNTING CLEARANCES

Schwank STR Series tube heaters must be
mounted with minimum clearances between
the reflector surface and combustibles as
shown in FIGURE 1, TABLE 2 (page 3).
For recommended heater placement refer to
TABLE 3 (page 3).
of
correct diameter,
BURNER KIT
JS-R045-A N/L
JS-R045-A N/L
JS-R060-A N/L
JS-R060-A N/L
In a garage installation, the minimum
clearance from the bottom of an infra-red
heater to the upper surface of a vehicle shall
not be less than the certified clearance to
combustible material as indicated on the
heater.
Carefully survey area to be heated. For best
results, whenever possible, place burner and
combustion chamber in coldest area.
STR TUBE KIT PART # & QUANTITY
REQUIRED
Stand-Alone Kits Only
TS-
TS-
4510-
4520-
CX
CX
1
1
Heaters should also be located in relation to
building construction and equipment, to
allowing a minimum clearance of 24 inches
from end of burner housing to enable
servicing and cleaning of burner, blower and
controls.
Page 2
TS-
TS-
1420-
1430-
CX
CX
1
1
SP-MSTR-AC-11A
STR Manual
RD: NOV, 2003
RL: 11
KH

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents