150R Mill Resistor Installation - Audio Note Interstage Mono Block 300D Instruction Manual

150R Mill Resistor Installation

Our next step is to install the 150 ohm Mills Power Resistor – this resistor is installed against the chassis – use the 2 x M3
countersunk 10mm screws and M3 nuts to secure into position
Copyright © 2010 AudioNote Kits
www.AudioNoteKits.com
audionotekits@rogers.com
Install the tang strip as shown with the
PEMS (little threaded standoffs) facing
up to the sky.
Now use the black or stainless M3
10mm screws and m3 nuts to secure
the tang strips to the chassis.
You can position the front insert plate
in the chassis just to see how it fits but
we will not be securing it in place now
– we will be building on the front insert
plate and installing the completed
section into the mono block later on!
Page 6