Installing The Mains Transformer - Audio Note Interstage Mono Block 300D Instruction Manual

Installing the Mains transformer

Primary Side
Copyright © 2010 AudioNote Kits
www.AudioNoteKits.com
audionotekits@rogers.com
We are going to install the T-199 Mains transformer now into position.
I suggest you lay the transformer upside down beside the chassis in the format
shown.
The Mains transformer has a primary side (0 110 120 etc.) and a secondary
(400 300 0 300 400 etc).
The Primary is the side with less wires - these wires are connected to the IEC
or AC inlet socket – so let's position the transformer so that it the primaries are
situated at the back of the chassis.
Now install the rubber strips into position over the holes so that the transformer
can sit on top of these and isolate from the chassis and secure the mains
transformer in place.
Once all the wires are fed through you can use a cloth to wipe off any excess
WD40 spray.
The primaries for
transformer can be threaded through
the grommet hole quite easily but the
secondaries will need a little help – we
suggest you give the secondary wires
a light spray with the WD40 so that
they can slide through the grommet
hole a little easier.
Continue feeding the wires through while
the mains transformer lies on its side as
shown.
Here you can see the completed
Mains transformer installation.
the Mains
Page 10