General Monitors TA402A Instruction Manual page 24

User Interfaces
20
Setup Check & Setup Modes (
ENTERING THE INHIBIT MODE
n
This option applies to the Setup Mode
only: If the password option is disabled,
or after the correct password has been
entered, the display will indicate In for
five seconds (figure 15). Pressing the
Mode/Select
displayed, will cause the unit to enter the
Inhibit mode by inhibiting the alarm
outputs. After the Model TA402A has
entered the Inhibit mode, pressing the
Mode/Select switch causes the unit to
return to normal operation (see section
5.3). If it is desired to enter the Setup
Mode, do not press the Mode/Select
switch for the five seconds In is
displayed.
A2 ALARM OPTIONS
n After the Inhibit mode option, the A2
LED on the front panel will be flashing
while the Energized/De-energized option
is displayed (figure 16). The display will
indicate the current selection, (En or
dE). Press the Mode/Select switch until
the desired
De-Energized is the factory default for
this selection.
)
con tin ued
In
switch while
Fig ure 15
option is displayed.
is
n The A2 LED on the front panel will
be
latching/non-latching option is displayed
(figure 17). The display will indicate the
current selection, (nL or LA). Press the
Mode/Select switch until the desired
option is displayed.
factory default for this selection.
General Monitors
Fig ure 16
flashing while
Latching is the
Fig ure 17
the