Forward-Facing Belt Installation - BESAFE iZi Combi ISOfix User Manual

Forward-facing belt installation

1. When mounting in the back seat of the vehicle, push the
front seat of the vehicle forward as much as possible.
2. When mounting in the front seat of the vehicle, adjust the
back rest in an upright position.
3. Install the wedge on the bottom of the seat; position the
hooks in the hole. (42) Rotate the wedge until you hear
click. (43, 44)
4. Install the seat in forward facing position without front
brace and the floor support in folded up position.
5. Put the child seat on the seat of the vehicle. Unlock the belt
clamps. (45)
6. Release the release handle at the back of the head rest
and push the head rest down while keeping the head rest
upright. (46)
7. Pull the hip belt around the bottom base of the seat and
click the car belt in the buckle. (47)
8. Position the hip belt over the belt guiding hook. (48)
9. Put the shoulder belt through the belt clamps. Make sure
the belt is not twisted. (49)
10. Push the seat firmly into the car seat.
11. Tight installation is most important for forward facing seats.
Tension the belts as follows (49): Pull the shoulder belt
upwards (A). Have a firm grip on the shoulder belt in the
seat area B. Close the clamp on the inner side C. Pull upper
belt part on the door side and close clamp D. (50)
12. Adjust the belt guiding hook outwards with the ratchet.
Continue tightening until the seat is pressed well into the
back rest of the car seat. Push the head rest in the correct
position (refer to 'Positioning of the child' on 18). The seat is
now ready to use. (51)
16
Removing the seat
1. Loosen the tension in the car belt by moving the belt guiding
hook inwards with the ratchet.
2. If the seat is installed in the back seat of the vehicle, push
the front seat of the vehicle forward as much as possible.
3. Unlock the belt clamps and unlock the car belt.
4. Remove the car belt and remove the seat from the vehicle.
17