Panasonic Lumix DMC-LX2 Operating Instructions Manual page 108

• Do not use any other USB connection
cables except the supplied one.
• While [ACCESS] is being displayed, do
not disconnect the USB connection cable.
• Data transmission takes time when a card
contains a large number of pictures.
• If the remaining battery power is
exhausted during communication, the
recorded data may be damaged. When
you connect the camera to the PC, use a
battery with sufficient battery power (P13)
or the AC adaptor (DMW-AC5; optional).
• If the remaining battery power becomes
low while the camera and the PC are
communicating, the status indicator blinks
and the alarm beeps. In this case, stop
the communication at once on the PC.
• When connecting the camera to a
Windows 2000 OS PC with the USB
connection cable, do not replace the
card while the camera and the PC are
connected. The information on the
card may be damaged. Disconnect the
USB connection cable before replacing
the card.
• Pictures edited or rotated with a PC may
be displayed in black in playback mode
(P35), multi playback (P76) and calendar
playback (P77).
• For information about this, refer to the
separate operating instructions for PC
connection.
• Refer to the operating instructions of the
PC, too.
• If a card is not inserted when the camera
is connected to the PC, you can edit or
access the picture data on the built-in
memory. If a card is inserted, you can edit
or access the picture data on it.
108
VQT0Y66
Connecting to other equipment
• You cannot switch between the built-in
memory and the card while the camera is
connected to the PC. When you want to
switch between the built-in memory and
the card, disconnect the USB connection
cable, insert (or remove) the card and
then connect the USB connection cable to
the PC again.
• When you change the mode dial to print
mode [
the PC, [PLEASE RE-CONNECT THE
PRINTER.] appears on the camera's LCD
monitor. Before reconnecting the camera
to a printer, change the mode from [
to another one and make sure that data
transmission is not in progress.
([ACCESS] appears on the camera's LCD
monitor while data transmission is in
progress.)
] with the camera connected to
]