Xerox WorkCentre XK50cx Service Manual page 10

3-4 ADF Scanner Unit Assembly
1. Before you disassemble the scanner unit
assembly, you should remove
Rear cover (See page 3-2)
2. Unplug three connector and remove the one
screw securing the ground wire to the bracket.
3. Remove two screws securing scanner unit
assembly.
4. Remove one screw and take out the PCB cover.
5. Unplug the harness from the main PBA.
You should connect or remove the FPC cable
vertically to avoid the FPC cable pin damage.
Disassembly and Reassembly
3-3