American Dynamics SpeedDome RASEL Series Installation And Service Manual page 8

16. Insert the dome into the hole in the ceiling.
17. Turn each of the two locking screws clockwise
to fully extend the "swing out" mounting clips
and to seat them tightly against the top surface
of the ceiling.
18. Apply power to dome.
Note: When power is applied, the dome
checks its function by performing a homing
routine during which the camera pans and then
either goes to the start point of the "apple peel"
pattern or if powered up once before, to the
last position in memory. Once the camera
stops, the camera is online and is ready to be
controlled.
Also, green, red, and yellow LEDs will light in
various patterns to indicate status. Typically,
you do not need to view these LEDs unless a
failure occurs during or after the routine. See
"Troubleshooting" for an explanation of the
LED patterns.
SPEEDDOME OPTIMA LT INDOOR CAMERA DOME INSTALLATION AND SERVICE GUIDE (8200-0181-01, REV. C)
19. Once the homing routine completes, affix the
bubble to the dome as follows:
a. Place the large hole at the end of the
lanyard over the screw head of the bubble
and pull its end to snap it in place. Loop
the lanyard to the inside of the housing.
b. Center the bubble over the dome housing
and align its tabs with the mating tabs in
the housing.
c. Turn the bubble clockwise until it catches
the tabs and stops.
8 of 14