American Dynamics SpeedDome RASEL Series Installation And Service Manual page 7

12. Attach a BNC connector to the video cable (if
not using the Twisted Pair Adapter). Also
attach the orange 3-pin power plug to
connector P10 and the gray 2-pin data
communications plug to connector P9. Wire
colors in diagram refer to cables supplied by
Sensormatic.
Note: Use a small screwdriver to tighten the
connector screws. DO NOT over tighten the
connectors!
13. Plug video (or Twisted Pair Adapter), power,
and data communications cables into their
mating connectors in the top of the dome
housing.
WARNING!
!
the source when connecting cables.
Otherwise, the dome will operate
during installation.
14. Reattach the cover plate to the dome housing.
SPEEDDOME OPTIMA LT INDOOR CAMERA DOME INSTALLATION AND SERVICE GUIDE (8200-0181-01, REV. C)
Ensure power is off at
15. Using safety wire, attach the dome to a strong
structural ceiling member as follows:
a. Find a strong structural member capable of
supporting the dome. Wrap one end of the
wire around this member and twist the wire
around itself four times to secure.
b. Run the other end of the wire through one
of the holes above the swing out tabs.
Twist the wire around itself four times to
secure.
c. Ensure the wire is taut!
!
7 of 14
WARNING! Keep the wire as
taut as possible. Do not secure
to any component of a fire
control system.