Silvercrest NTK-2100 User Manual And Service Information page 5

Your computer has detected the USB device, automatically installed the driver and now shows the following
message:
The operating system confirms that the device has been correctly integrated into the system and is ready for
immediate use.
If the device is unable to establish a connection with the computer, unplug the USB connector for a few seconds
and then reconnect the device to the computer. You can also try a different USB port on your computer.
Please read the notes on the following pages concerning the individual products of the Notebook-Traveller-Kit.
Cable-Winding Mechanism
The USB mouse, the numeric keypad, the headset, the USB extension cable, the modem connection cable and the
network cable have a smart cable-winding mechanism. By using this mechanism you can have the connection
cable at your required length.
To do this, pull gently on both ends of the cable at the same time until the required length is reached. When you
stop pulling, the winding mechanism pulls the cable from both sides in a little until it locks at the next ratchet.
To wind the cable in, carefully pull on both ends again. The ratchet is released and the cable winds itself back into
the housing. To ensure that the cable winds up correctly when the cable is rolled off completely, release the
connector after the cable is wound up completely.
4
(Fig.: Installation completed)
Pull the cable from both sides at the
same time to the desired length.
The mechanism will wind
the cable back slightly until
it locks in place.