Scanner Emulation Synapse Cable Defaults - Allen-Bradley 2755-HTG-4 Programming Manual

Scanner Emulation Cable
(Communication Setup)
This chapter provides the configuration bar codes for the scanner
emulation Synapse cable:
•
(Catalog No. 2755-HFC-SA1-01)

Scanner Emulation Synapse Cable Defaults

Scan the following bar code to set the scanner emulation cable to its
default values. Defaults are indicated with an asterisk *.
Scan this label to set the Scanner Emulation Synapse cable to the
default settings shown below.
Scanner Emulation
Synapse Cable
Emulation
Leading Margin
Decode LED
Emulation Timeout
Polarity
Unknown Characters
Convert All to Code 39
Code 39 to Code 39 Full ASCII
Parameter Set
Set Scanner Emulation Cable Defaults
Default Setting
Standard
80 Millisecond
Enabled
3 Seconds
Margin Low / Bar High
Send Bar Codes with Unknown
Characters
Disabled
Disabled
Parameter Set 1
Chapter
Code on
Page:
6–2
6–3
6–3
6–4
6–5
6–5
6–6
6–6
6–7
Publication 2755-6.7
6