Table of Contents
Advertisement
P–2
How to Use this Guide
The following shows a typical sequence for configuring a scanner.
1. Connect scanner to host and apply power.
2. Configure scanner.
3. Configure communications. Is the scanner
Refer to Application Specific Setups:
Enhanced Decoder, refer to Appendix B
Flexible Interface (RB) Module, refer to Appendix C
SLC Processor, refer to Appendix D
PLC Processor, refer to Appendix E
DTAM Plus DeviceNet, refer to Appendix F
5. If the decoded data needs to be modified before
4. Scanner is ready for operation. Use the test codes
Publication 2755-6.7
Preface
connected to an Allen-Bradley host device?
Yes
RS–232 Synapse Cable, refer to Chapter 2
IBM PC Wedge Cable, refer to Chapter 3
DEC VT520 Wedge Cable, refer to Chapter 4
DEC VT220/320/420 Wedge Cable, refer to Chapter 5
Scanner Emulation Cable, refer to Chapter 6
being transmitted to a host device, scan Advanced
Data Format codes in Appendix A.
found on the inside back cover of this guide.
No
Scan setup codes for cable:
Advertisement
Table of Contents
