Tks Ice Protection System High Flow Rate; Inadvertent Icing Encounter At Altitudes Above 20,000 Ft; Inertial Separator Malfunction; Propeller Anti-Ice System Malfunction - Kodiak 100 Series Information Manual

Table of Contents

Advertisement

Uncontrolled if printed
S e c t i o n 9
T KS I C E PROT EC T I O N

TKS ICE PROTECTION SYSTEM HIGH FLOW RATE

(
CAS MESSAGE SHOWN WITHOUT A LOW PRESSURE
TKS HI FLOW
TKS LOW PRESS
1. Ice Protection System .................................................................... MONITOR
2. Ice Protection Fluid Quantity.......................................................... MONITOR
3. Icing Conditions .......................................................................... AVOID/EXIT

INADVERTENT ICING ENCOUNTER AT ALTITUDES ABOVE 20,000 FT

1. IGNITION Switch .......................................................................................ON
2. SURFACE/PROP Switch .............................NORM (Select HIGH if required)
3. WINDSHIELD Switch .................................................................................ON
4. Left and Right Pitot Heat Switches ............................................................ON
5. Engine Inlet Inertial Separator .......................................................... BYPASS
6. Cabin Heat/Defrost ....................................................................................ON
7. Airspeed........................................................................190 KTAS MAXIMUM
8. Altitude ............. DESCEND TO 20,000 FEET (or lower as soon as practical)
9. IGNITION Switch ........................OFF (when icing conditions are exited)

INERTIAL SEPARATOR MALFUNCTION

(
INLET NOT BP
1. Primary ENG INLET Switch ................................................ VERIFY BYPASS
2. Override ENG INLET Switch ............................................................ BYPASS
If inertial separator fails to move to BYPASS (
message still shown):
1. IGNITION Switch .......................................................................................ON
2. Icing Conditions .............................................EXIT AS SOON AS POSSIBLE

PROPELLER ANTI-ICE SYSTEM MALFUNCTION

If uneven or inadequate anti-icing of the propeller blades is indicated by
vibration:
1.
TKS NRM MODE
PFD
(SURFACE PROP Switch in NORM or HIGH position)
1. Propeller Lever ........................................... EXERCISE (Then to MAX RPM)
If excessive propeller vibration continues:
1. SURFACE/PROP Switch ........................................................................ MAX
2. Icing Conditions .............................................EXIT AS SOON AS POSSIBLE
9 . 4 -12
D O N OT U S E FO R FL I G H T O PE R AT I O N S
ANNUNCIATION)
CAS MESSAGE SHOWN)
or
TKS HI MODE
P i l o t 's O p e r a t i n g H a n d b o o k S u p p l e m e n t
INLET NOT BP
CAS message VERIFY SHOWN ON
1 0 0 S E R I E S
CAS

Advertisement

Table of Contents
loading

Table of Contents