Autopilot On - G1000 Annunciations; Flight Director Only - G1000 Annunciations; Fd/Ap Off - G1000 Annunciations - Kodiak 100 Series Information Manual

Uncontrolled if printed

AUTOPILOT ON - G1000 ANNUNCIATIONS

The autopilot mode of operation is determined by referencing the entire
annunciation block. When the autopilot master switch is in the AP/FD
position, the mode of operation is shown in the annunciation block as follows:
RDY
No Modes Selected
AP
HDG
One Mode (Heading) Selected
AP
HDG
Multiple Modes (Heading and Altitude) Selected
Figure 9.1-8 – AP Master Switch, FD/AP Mode Engaged

FLIGHT DIRECTOR ONLY - G1000 ANNUNCIATIONS

When the autopilot master switch is placed in the FD position, the autopilot
servos are disengaged and the pilot must now manually steer the aircraft
to match the flight director command bars as signaled by FD being shown
on the annunciation block and an aural autopilot disconnect tone. The
annunciation block for this condition is as follows:
RDY
No Modes Selected
HDG
One Mode (Heading) Selected
FD HDG
Multiple Modes (Heading and Altitude) Selected,
Flight Director Command Bars Displayed
Figure 9.1-9 – AP Master Switch, FD Mode Engaged
NOTE :
The Flight Director Command Bars and the FD Annunciation will
not appear unless a roll mode
GPSS) AND a pitch mode (ALT, VS) are selected.

FD/AP OFF - G1000 ANNUNCIATIONS

When the AP/FD master switch is in the OFF position, the annunciation block
is shown as follows:
Flight Director and Autopilot OFF
Figure 9.1-10 – AP Master Switch, All Modes OFF
P i l o t 's O p e r a t i n g H a n d b o o k S u p p l e m e n t
1 0 0 S E R I E S
(HDG, NAV, NAV APR, REV, REV APR, NAV
D O N OT U S E FO R FL I G H T O PE R AT I O N S
S e c t i o n 9
S -T EC AU TO PI LOT
FD/AP
F D / A P
ALT
FD
F D
ALT
OFF
O F F
F D / A P
ALT
F D
ALT
O F F
F D / A P
F D
O F F
9 .1- 2 3