Seat Removal And Installation - Kodiak 100 Series Information Manual

Uncontrolled if printed
S e c t i o n 7
AIRPLANE & SYSTEMS DESCRIPTIONS

SEAT REMOVAL AND INSTALLATION

NOT E : The Passenger and Crew Seat installation and removal
instructions contained in this section can be performed by a pilot without
a logbook entry. If any seats are removed, a weight and balance for flight
must be calculated using the procedures defined in "Section 6" of this
manual.
Tools Required to Remove the Passenger and Crew Seats
The passenger and crew seats can be removed using the following tool(s):
a. Standard Flat Head Screw Driver (Passenger Seats)
b. Standard Phillips Head Screw Driver (Crew Seats)
Seat Tracks
If equipped, seat tracks are marked with station identification markings every
10 inches, starting at FS (Fuselage Station) 50.0. These markings will assist
the operator in quickly installing seats. Refer to the following example of how
to properly install a seat.
Example: To install a seat in Row 3 (FS 115.0), locate fuselage station
marking FS 110.0 and count 5 seat track notches AFT. Insert the seat lock
paw into FS 115.0 and move the seat 1/2 inch AFT and engage the seat track
lock. This is the location for the center of the seats track lock pin.
CONFIGURATION A
EXAMPLE FIGURE:
(FS 115.0 , Row 3)
Insert seat into track and move
AFT 1/2 inch to engage lock.
For weight and balance calculations, the individual seat weights and seat CG
locations are provided in "Section 6" of this manual.
7- 6 4
D O N OT U S E FO R FL I G H T O PE R AT I O N S
Figure 7-57 – Seat Track Marking Example
Track Station Markings
(Every 10 Inches)
Note: A Black Diamond
identifies each station.
P i l o t 's O p e r a t i n g H a n d b o o k
1 0 0 S E R I E S