Kodiak 100 Series Information Manual page 358

Uncontrolled if printed
S e c t i o n 7
AIRPLANE & SYSTEMS DESCRIPTIONS
Strobe Lights
A high intensity LED strobe light system is installed on the airplane. The
system includes two white strobe lights, one on each wing tip. The lights
enhance the anti-collision protection for the airplane and meet the FAA
requirements for night operations. The strobe lights are protected by a circuit
breaker, labeled STROBE.
WA RNI NG :
Utilization of the high intensity strobe lights while performing ground
operations at night can be of considerable nuisance and distraction to
ground personnel and other pilots. Do not operate the strobe lights while
in fog, clouds or haze. The reflection of the beams of light can cause
vertigo or disorientation.
Flashing Beacon Light
An aviation red LED flashing beacon is installed on the top of the fuselage
near the vertical tail. The flashing beacon is utilized as an additional
source for anti-collision protection in flight and for recognition during ground
operations. The flashing beacon is protected by a circuit breaker, labeled
NAV LIGHT.
WARN I NG :
when flying through fog, clouds or haze. The reflection of the light may
cause vertigo or disorientation.
BEACON STROBE
ON ON
OFF OFF
ENG INLET
BYPASS
PULL TO
UNLOCK
Figure 7-80 – Right Switch Panel:
7-114 b
D O N OT U S E FO R FL I G H T O PE R AT I O N S
The strobe lights should be turned off when taxiing.
The flashing beacon and strobe lights should not be used
LIGHTS
NAV TAXI
ON ON
PULSE
OFF OFF
ICE PROTECTION
PITOT
L HEAT R
ON ON
BYPASS
OFF OFF
NORMAL
Xenon/Incandescent/HID System
INTERIOR
LANDING CABIN
INSTRUMENT
PANEL
ON ON
NORM
OFF
OFF
SURFACE/ WIND BACKUP
PROP SHIELD
ON
MAX
HI
OFF
NORM
OFF
P i l o t 's O p e r a t i n g H a n d b o o k
1 0 0 S E R I E S
SWITCH / CB
PANEL
ICE LIGHT
PUMP
ON ON
OFF OFF