Electrolux FAVORIT 88421 I User Manual page 23

Fault code and malfunction
• continuous flashing of the light of the run-
ning programme
•
appears in the digital display.
• intermitted audible signal
Anti-flood device is activated.
The programme does not start.
Once these checks have been carried out, switch on the appliance: the programme will
continue from the point at which it was interrupted.
If the malfunction or fault code reappears contact the Service Force Centre.
For other fault codes not described in the above chart, please contact your local Service
Force Centre, quoting the model (Mod.), product number (PNC) and serial number (S.N.).
This information can be found on the rating plate located on the side of the dishwasher
door.
So that you always have these numbers at hand, we recommend you to make a note of
them here:
Mod. : . . . . . . . . . . . . . . . . . . . . . . .
PNC :. . . . . . . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . . . . . . . .
The dishes are not clean
The dishes are wet and dull
Downloaded from DishWasher-Manual.com Manuals
• Close the water tap and contact your local
• The dishwasher's door has not been properly
• The main plug is not plugged in. Insert the
• The fuse has blown out in the household fuse
• Delay start has been set.
The wash results are not satisfactory
• The wrong washing programme has been se-
• The dishes are arranged in such a way as to
• The spray arms do not rotate freely due to
• The filters in the base of the washing com-
• Too little or no detergent has been used.
• Where there are limescales deposits on the
• The drain hose connection is not correct.
• The salt container cap is not properly closed.
• Rinse aid was not used.
• The rinse aid dispenser is empty.
What to do if...
Possible cause and solution
Service Force Centre.
closed. Close the door.
main plug.
box.
Replace the fuse.
If dishes are to be washed immediately, cancel
the delay start.
lected.
stop water reaching all parts of the surface.
The baskets must not be overloaded.
incorrect arrangement of the load.
partment are dirty or incorrectly positioned.
dishes; the salt container is empty or the in-
correct level of the water softener has been
set.
23