Shifting The Display; Centering Cursor Position; Centering Own Ship's Position; Stopping/Starting Plotting And Recording Of Track - Furuno GP-150 Installation Manual

2. TRACK
Cursor turned off
Ship's position (in latitude and longitude or
LOPs), speed and course appear on the
display.
Own ship
Own ship position
mark
in latitude and longitude
34° 23.456´ N 135°
Figure2-2 Data display when the cursor is
turned off
2.4

Shifting the Display

The display can be shifted on the Plotter 1
and Plotter 2 displays, with the CURSOR
ON/OFF key. When own ship tracks off the
display it is automatically returned to the
screen center.
1) Press the CURSOR ON/OFF key to turn
off the cursor.
2) Press the cursor pads. The display shifts
in the direction of the cursor pads
pressed.
2-2
D3D 100m
45.678´ E
SAFE
BRG
234°
COG
345°
RNG
123°
nm
SOG
12.3
kt
Course
Speed
2.5 Centering Cursor
Position
1) Press the CURSOR ON/OFF key to turn
on the cursor.
2) Press the cursor pad to position the
cursor.
3) Press the CENTER key.
2.6 Centering Own Ship's
Position
1) Press the CURSOR ON/OFF key to turn
off the cursor.
2) Press the CENTER key.
Note: When own ship's position reaches an
edge of the screen, the display moves
to set own ship's position center of the
display.
2.7 Stopping/Starting
Plotting and Recording
of Track
The GP-150 stores 2,000 points of track and
marks. When the memory becomes full the
oldest track is erased to make room for the
latest.
Procedure
Press the PLOT ON/OFF key to start/stop
recording and plotting of track.
When plotting is resumed
"Resuming track plot" appears at the center
of the display for about three seconds.
When plotting is stopped
"Stopping track plot" appears at the center of
the display for about three seconds and "
appears at the left side of the display. ("
does not appear on the Navigation and Data
displays.)
"
H
"
H