Furuno GP-150 Installation Manual page 50

Selecting Mark Shape/Line
Type
1) Press MENU ESC and 2.
2) Press ▲ or ▼ to select Mark Shape (or
Mark Line).
3) Press ◄ or ► to select mark shape (or
mark line) desired.
4) Press NU/CU ENT.
5) Press MENU ESC.
Entering Event Mark
Press EVENT MOB momentarily.
Entering MOB Mark
1) Press EVENT MOB (about three seconds)
until "Save MOB position" appears.
2) Press NU/CU ENT.
Starting/Stopping Plotting and
Recording of Track
Press PLOT ON/OFF. "
recording is disabled. "
recording is enabled.
Registering Waypoints
A waypoint can be entered by several ways.
Below is the procedure for entry by the
cursor.
1) Press WPT RTE.
2) Press 1 to select Cursor.
3) Operate the cursor pad to place the cursor
on the position desired for a waypoint.
4) Press NU/CU ENT.
5) Press ▼ to select Mark column.
6) Press ◄ or ► to select mark shape.
7) Press NU/CU ENT.
8) Enter comment (maximum 12 alphanu-
meric characters).
P U B . N O . O S E - 4 4 4 0 0 - A
( 0 6 0 2 , H I M A ) G P - 1 5 0 / D U A L
This manual is printed with
2
soy ink.
" appears when
H
" disappears when
H
9) Choose "ENTER" and press NU/CU ENT.
10)Press NU/CU ENT.
Registering Routes
1) Press WPT RTE.
2) Press 6 (5 for Dual) to select Route
Planning.
3) Press ▲ or ▼ to select route number.
4) Press ►.
5) Enter waypoint number (three digits).
6) Press ▼.
7) Repeat steps 5 and 6 to enter next
waypoint number.
8) Press MENU ESC twice to quite.
Setting/Cancelling Destination
Destination can be set by four ways. Below
is the method for setting destination by the
cursor.
1) Press GOTO.
2) Press 1 to select Cursor.
3) Place the cursor on the position to set as
destination.
4) Press NU/CU ENT twice.
To cancel destination, press GOTO, 5,
NU/CU ENT.
Setting the Arrival Alarm
1) Press MENU ESC and 4.
2) Press ▲ or ▼ to select Arrival/Anchor.
3) Press ◄ to select "Arr."
4) Press ▼ to select "Alarm Range."
5) Enter arrival alarm range.
6) Press NU/CU ENT.
7) Press MENU ESC.
The buzzer may be silenced by pressing
CLEAR.