Furuno GP-150 Installation Manual page 109

DGPS
1) Press MENU ESC, 9 and 7 to display the
WAAS/DGPS SETUP menu.
Frequency appears
when "Man" is selected.
WAAS/DGPS SETUP
MODE Of
WAAS SEARCH Auto Man (GEO=134)
CORRECTIONS DATA SET : 00
DGPS Station Auto Man (ID=0274)
Freq. 323.0kHz
Baud Rate 200
: Select
ENT : Enter
MENU : Escape
Figure 8-26
2) Press to select DGPS Station.
3) Press or to select Auto or Man.
For automatic search, the GP-150
automatically search DGPS reference
station.
For manual search, select frequency of
DGPS reference station and select the
transmission rate of that.
GPS Of
bps
Reference
1) Press MENU ESC. 9 and 7 to display the
DGPS SETUP menu.
2) Set DGPS MODE On.
3) Press or to select DGPS Station.
4) Press or to select Man.
5) Enter four digit ID number. You can clear
an entry by the CLEAR key. If the
number entered is invalid, the buzzer
sounds and the message "INVALID ID"
appears on the display for three seconds.
If there is no ID number, press the
CLEAR key.
6) Press the NU/CU ENT key.
7) Enter frequency in four digits (283.5kHz
to 325.0kHz).
8) Press the NU/CU ENT key. "Baud Rate"
appears in reverse video.
9) Press or to select baud rate; 25,
50, 100 or 200bps.
10) Press the MENU ESC key.
Setup for external DGPS beacon
receiver
When an external DGPS beacon receiver is
connected to the DATA 4 connector, set up
the GP-150 according to specification of
DPGS beacon receiver connected as
follows.
1) Press MENU ESC, 9 and 5.
2) Press or to select Level.
3) Press or to select level; RS232C
or RS422.
4) Press the NU/CU ENT key.
5) Press or to to select DGPS.
6) Press ▼ to select To Next Page.
8. MENU SETTINGS
8-11