Installation - Alpine X800D-U Owner's Manual

Installation

X800D-U user
To install the X800D-U, refer to the manual in the
separately purchased installation kit for each car type.
Caution
Do not block the unit's fan or heat sink, thus preventing
air circulation. If blocked, heat will accumulate inside
the unit and may cause a fire.
<example>
Air ventilation hole
Rear of the Unit
Caution concerning the installation location
1
Before installing, make sure that the opening and
closing of the display will not interfere with
operation of the gear shift.
Movable Display
2
Angle of installation
Install at an angle between horizontal and 30°. Note
that installing at an angle outside of this range will
result in a loss of performance and possibly
damage.
0 - 30°
3
Mounting the GPS Antenna inside the vehicle.
1 Clean the mounting location.
2 Put on the GPS Antenna mounting plate.
3 Mount the GPS Antenna.
• Mount the GPS Antenna on a flat plane of the dash board or
Heat sink
• Some thermal reflection type or thermal absorption type glass
• Make sure the GPS Antenna is not covered (obstructed) by any
4
Mounting the Microphone.
For safe use, make sure of the following:
• location is stable and firm.
• driver's view and operations are not obstructed.
• microphone is located where the driver's voice can be easily
When you speak into the microphone, you should not have
to change your driving posture. This may cause a
distraction, taking your attention away from safely driving
your vehicle. Carefully consider direction and distance while
mounting the microphone. Confirm that the driver's voice
can be easily picked up at the selected location.
Cable clamp
(Sold separately)
Antenna mounting plate
rear tray.
may interrupt high frequency waves. If reception is poor with
the antenna installed inside the car, try to mount the antenna
outside the car.
metallic surface or object.
picked up (on the sun visor, etc.).
Microphone
GPS Antenna
109
-EN