Car Setup; Steering Wheel Setting; Installation Setup; Rear Camera Cover Setup - Alpine X803D-U User Manual

Car Setup

[Car] is selected on the General Setup Menu screen in step 1. See
"General Setup" (page 28).

Steering wheel Setting

Set this item when Apple CarPlay is used/Android smartphone which
installed Android Auto App is connected.
This setting influences Apple CarPlay/Android Auto mode.
Setting item:
Steering wheel
Setting contents:
Left (Initial setting) / Right

Installation Setup

Vehicle Setup enables you to check the installation status of Reverse
Lead/Parking Brake Lead/Speed Signal/GPS Status/GPS Reception/VP
Learning/Sensor Diagnosis, etc.
Setting item:
Installation Status
The Installation check screen is displayed.
• Depending on your vehicle, some installation status may not be checked
via this function.

Rear Camera Cover Setup

Use this function when your vehicle's rear view camera is equipped with
an electric protective cover. When you turn this setting to "On", the rear
view camera cover will be open automatically during rear camera
source. Make sure the Rear Camera Cover is connected to Power
Antenna Lead (Blue) correctly. Please refer to the "Connections" section
of "Installation Manual" for details.
Setting item:
Rear Camera Cover
Setting contents:
Off (Initial setting) / On
38
-EN

Sources Setup

[Sources] is selected on the Setup main screen in step 3. See "Setup
Operation" (page 25).
Sources Setup Menu screen
<Setting items>
Radio
PI Seek
RDS Regional
PTY Language
PTY31
FM Tuner Setting
DAB
Emergency Announcement
Announcement Mode
FM Linking
DAB Antenna Power
1
AUX*
2
AUX Name*
2
Direct Touch*
2
Signal*
3
HDMI*
4
Apple CarPlay*
*1 This setting cannot be changed while the AUX source is being selected
or "Camera with audio" is set to "On" (page 44).
*2 This setting is only available when "AUX" is set to "On" (
*3 This setting cannot be changed while the HDMI source is being
selected.
*4 This setting cannot be adjusted when an iPod/iPhone is connected or
Apple CarPlay/iPod source is being selected.
The following steps 1 to 3 are common to each "Setting
item" of Audio Setup. See each section for details.
1
Select the desired item.
2
To switch the setting, touch [ ], [ ], [ ], [ ], or mark the
checkboxes "Off" (
• If " " appears, there is a further hierarchy. Touch the desired
item.
3
Touch [ ] to return to the main source screen.
• To return to the previous List screen, touch [ ]. For details, see
"About Basic Operation for List Screen" (page 17).
).
) or "On" ( ).