Nilfisk-ALTO SCRUBTEC 545B Service Manual page 8

ENGLISH
GENERAL INFORMATION
WARNING! (SCRUBTEC 545B, 545BL, 553B, 553BL, BOOST 5, 653B, 653BL, 651BCL, 661BL)
– Do not pull or carry the machine by the battery charger cable and never use the battery charger cable as
a handle. Do not close a door on the battery charger cable, or pull the battery charger cable around sharp
edges or corners. Do not run the machine on the battery charger cable.
– Keep the battery charger cable away from heated surfaces.
– Do not charge the batteries if the battery charger cable or the plug are damaged. If the machine is not
working as it should, has been damaged, left outdoors or dropped into water, return it to the Service
Centre.
– Before using the battery charger, ensure that frequency and voltage values, indicated on the machine
serial number plate, match the electrical mains voltage.
– Do not smoke while charging the batteries.
– To reduce the risk of fire, electric shock, or injury, do not leave the machine unattended when it is plugged
in. Before performing any maintenance procedure, disconnect the battery charger cable from the electrical
mains.
WARNING! (SCRUBTEC 545E, 553E, 653E)
– The machine power supply cable is grounded and the relevant plug is grounded too. In case of machine
malfunction or breakdown, grounding connection reduces the risk of electric shock.
– The power supply cable plug must be connected to an appropriate outlet, which is grounded according to
law in force. Improper connection can cause electric shock.
– Do not tamper with the power supply cable plug. If the power supply cable plug cannot be connected to
the outlet, have new grounded outlet installed by a qualified technician, according to the law in force.
– Before connecting the power supply cable to the electrical mains, check that frequency and voltage,
shown on the machine serial number plate, match the electrical mains voltage.
– Do not unplug the machine by pulling the supply cable. To unplug, grasp the plug, not the cable.
– Do not handle the plug or the machine with wet hands.
– Turn off all controls before unplugging.
– Regularly check the power supply cable for damages, cuts, cracks and wear. If necessary, replace it.
– If the power supply cable is damaged, contact the Nilfisk Service Center for replacement.
– Do not pull or carry the machine by the power supply cable and never use the power supply cable as a
handle. Do not close a door on the power supply cable, or pull the power supply cable around sharp edges
or corners. Do not run the machine on the power supply cable.
– The brushes must not come into contact with the power supply cable.
– Keep the power supply cable away from heated surfaces.
– To reduce the risk of fire, electric shock, or injury, do not leave the machine unattended when it is plugged
in. Disconnect the machine from the electrical mains when not in use and before performing maintenance
procedures.
– If the machine:
• does not work properly
• is damaged
• has water or foam leaks
• has been left outdoors exposed to bad weather conditions
• is wet or has been dropped into water
turn it off immediately and contact the Nilfisk Service Center or a qualified technician.
6
SERVICE MANUAL
SCRUBTEC 545B / 545BL / 553B / 553BL / BOOST 5
653B / 653BL / 651BCL / 661BL / 545E / 553E / 653E
9097062000(2)2009-06