Pager Messages; Event Code In Page; Sensor Number Or User Number In Page - GE Security Concord 4 series User Manual

Concord 4 Series Security Systems

Pager Messages

When an event is reported on a numeric pager, the following information is included:
Although all three types of information can be reported on your pager, your pager service deter-
mines how the information will actually appear.

Event Code in Page

This number identifies what has happened.
Code
009 A sensor has been restored to its non-alarm state
111 System has been disarmed
115 Sensor test exit
118 System trouble has been fixed
119 System alarm condition has been cancelled
222 System armed to Level 2—STAY
333 System armed to Level 3—AWAY
555 System phone/sensor test
888 System has a trouble condition
999 System is in alarm condition
If a user arms the system to level 3 (AWAY) the pager will report that the system was armed to
level 3 (333). However, if the system is armed from a hardwired touchpad and the user does
not exit the premises, the arming level will revert to level 2 (STAY) without notifying the pager.

Sensor Number or User Number in Page

This number identifies who or what is causing the event.
Code
000 System event not caused by a sensor or user
001 — 096 Sensor numbers (1-96 for Concord 4, 1-32 for Concord Express V4)
600 — 829 User codes used (00-229 for Concord 4, 00-15 for Concord Express V4)
830 — 835 Partition master codes used (Concord 4 systems only)
846 System Master code used
847 Installer code used
848 Dealer code used
850 Quick Arm used
851 Keyswitch sensor used
852 System armed itself because it is being serviced or powered-up
Event Code
Last four digits of central
station account number
Sensor number or user number
Figure 6. Pager Messages
Indicates
Indicates
19