Using Snmp To Set Up Wep - Cisco Aironet 1200 Series Software Configuration Manual

Setting Up WEP
Step 6

Using SNMP to Set Up WEP

Cisco Aironet 1200 Series Access Point Software Configuration Guide
4-12
The three settings in the pull-down menu include:
No Encryption (default)—The access point communicates only with client
•
devices that are not using WEP. Use this option to disable WEP.
Optional—Client devices can communicate with the access point either with
•
or without WEP.
If you select Optional, Cisco Aironet client devices associating to the
Note
access point must be configured to allow association to mixed cells.
See the Cisco Aironet Wireless LAN Adapters Software Configuration
Guide for instructions on configuring Cisco Aironet client devices.
Full Encryption—Client devices must use WEP when communicating with
•
the access point. Devices not using WEP are not allowed to communicate.
Note You must select Full Encryption to enable Message Integrity Check
(MIC). See the
page 4-13
Click OK. You return automatically to the Security Setup page.
You can use SNMP to set the WEP level on the access point. Consult the
SNMP" section on page 2-10
Access points use the following SNMP variables to set the WEP level:
dot11ExcludeUnencrypted.2
•
• awcDot11AllowEncrypted.2
Table 4-2 lists the SNMP variable settings and the corresponding WEP levels.
"Enabling Message Integrity Check (MIC)" section on
for instructions on setting up MIC.
for details on using SNMP.
Chapter 4 Security Setup
"Using
OL-2159-01