Cisco Aironet 1200 Series Software Configuration Manual page 87

Chapter 3 Configuration
BOOTP Server Timeout (sec)
DHCP Multiple-Offer Timeout (sec)
DHCP Requested Lease Duration (min)
DHCP Minimum Lease Duration (min)
OL-2159-01
If specified by server—The access point loads configuration settings from an
•
.ini file on the server if the server's DHCP or BOOTP response specifies that
an .ini file is available. This is the default setting.
The Load Now button under the pull-down menu tells the access point to read an
.ini file immediately.
The Current Boot Server line under the pull-down menu lists the server that
responded to the access point's boot request. If all zeros appear, it means that the
access point is not using BOOTP/DHCP or that no server responded to the
BOOTP/DHCP request. The Specified ".ini" File Server line lists the IP address
of the server where the .ini file is stored. If all zeroes appear, it means that no file
server is set up to provide an .ini file.
This setting specifies the length of time the access point waits to receive a
response from a single BOOTP server. Enter the number of seconds the access
point should wait. This setting applies only when you select BOOTP from the
Configuration Server Protocol pull-down menu.
This setting specifies the length of time the access point waits to receive a
response when there are multiple DHCP servers. Enter the number of seconds the
access point should wait.
This setting specifies the length of time the access point requests for an IP address
lease from your DHCP server. Enter the number of minutes the access point
should request.
This setting specifies the shortest amount of time the access point accepts for an
IP address lease. The access point ignores leases shorter than this period. Enter
the minimum number of minutes the access point should accept for a lease period.
Cisco Aironet 1200 Series Access Point Software Configuration Guide
Server Setup
3-49