Using Command-Line Diagnostics
:vxdiag_routeshow
Cisco Aironet 1200 Series Access Point Software Configuration Guide
9-30
Use the :vxdiag_routeshow command to display current routing information for
the access point. The routing information might look like the following example:
ROUTE NET TABLE
destination
gateway
----------------------------------------------------------------------
0.0.0.0
10.84.139.129
10.84.139.128
10.84.139.141
----------------------------------------------------------------------
ROUTE HOST TABLE
destination
gateway
----------------------------------------------------------------------
127.0.0.1
127.0.0.1
----------------------------------------------------------------------
These are descriptions for each column in the route net and route host tables:
Destination—IP address of host to which access point is to be routed
•
Gateway—IP address of host for forwarding packets not in the access point's
•
subnet
Flags—see
Table 9-2
•
•
Refcnt—the number of hosts referencing this address
Use—number of packets forwarded
•
Interface—one of four possible interfaces:
•
emac0 for Ethernet
–
awc0 for internal radio
–
–
awc1 for external radio
lo0 for internal loopback
–
Follow the steps in the
open the CLI and enter the :vxdiag_routeshow command.
Chapter 9
flags
3
101
flags
5
for a list of flags
"Entering Diagnostic Commands" section on page 9-20
Diagnostics and Troubleshooting
Refcnt
Use
Interface
1
1932
emac0
0
0
emac0
Refcnt
Use
Interface
0
696
lo0
OL-2159-01
to