Cisco Aironet 1200 Series Software Configuration Manual page 77

Chapter 3 Configuration
Primary Port Settings
Default IP Address
OL-2159-01
Default IP Subnet Mask
•
The page also displays the access point's MAC address, its serial number, its
current IP address, and its current IP subnet mask.
Two options allow you to designate the access point's Ethernet port as the Primary
Port and select whether the Ethernet port adopts or assumes the identity of the
primary port.
Primary Port?—The primary port determines the access point's MAC and IP
•
addresses. Ordinarily, the access point's primary port is the Ethernet port, so
this setting is usually set to yes. Select yes to set the Ethernet port as the
primary port. Select no to set the radio port as the primary port.
Adopt Primary Port Identity?—Select yes to adopt the primary port settings
•
(MAC and IP addresses) for the Ethernet port. Select no to use different MAC
and IP addresses for the Ethernet port.
Some advanced bridge configurations require different settings for the Ethernet
and radio ports.
Use this setting to assign or change the access point's IP address. If DHCP or
BOOTP is not enabled for your network, the IP address you enter in this field is
the access point's IP address. If DHCP or BOOTP is enabled, this field provides
the IP address only if no server responds with an IP address for the access point.
The current IP address displayed under the Default IP Address setting shows the
IP address currently assigned to the access point. This is the same address as the
default IP address unless DHCP or BOOTP is enabled. If DHCP or BOOTP is
enabled, this field displays the IP address that has been dynamically assigned to
the device for the duration of its session on the network, and it might be different
than the default IP address.
You can also enter this setting on the Express Setup and AP Radio Identification
pages.
Cisco Aironet 1200 Series Access Point Software Configuration Guide
Ethernet Configuration
3-39