Toshiba e-STUDIO161 Service Manual page 49

Program
Program name
Key auto repeat
Key press time
Audible signals volume
Base setting beep signal
Number of copies limit
Use close paper size
Default tray setting
Default exposure mode
*3 e-STUDIO161 is as follows :
1 : Paper tray (factory default)
5 : Bypass tray
e-STUDIO161 USER PROGRAMS
No
Use this setting to select whether or not holding down a key causes
repeated input of the key. For keys that normally cause a set value to
25 increase when held down (for example, holding down the [ZOOM]
key), this program can be used to have the set value not change
when the key is held down.
Use this setting to select how long a key must be pressed for the
input to be accepted. By selecting a longer time, you can prevent
settings from being changed by the accidental pressing of a key.
26
This sets the volume of beep signals.
27
Use this to sound a beep when a base setting is selected.
28
Use this setting to select 99 or 999 for the maximum number of
29
copies.
When this function is enabled, printing in printer mode will
automatically continue using a different size of paper if the specified
30
size of paper runs out in all trays. This feature does not function in
copy mode.
Use this program to select a default tray. This tray is automatically
selected each time the power is turned on or each time the machine
31
reverts to the initial settings.
Use this program to set "AUTO", "TEXT", or "PHOTO" as the default
exposure mode.
32
Description
8-2
Default Parameters
0 (OFF)
1 (ON)
ON
1 (Minimum
(current response speed))
Minimum
2 (0.5sec)
(current
response 3 (1.0sec)
speed)
4 (1.5sec)
5 (2.0sec)
1 (short beep)
short beep 2 (long beep)
3 (OFF)
0 (OFF)
OFF
1 (ON)
1 (99 copies)
999 copies
2 (999 copies)
0 (OFF)
1 (ON)
OFF
1 (Upper paper tray) *
Upper
2 (Lower paper tray) *
paper tray
5 (Bypass tray) * 3
1 (AUTO)
AUTO 2 (TEXT)
3 (PHOTO)
3
3