Daikin Enfinity VFC Installation And Maintenance Manual page 22

Figure 21: Sizes 042-070 (575/60/1)
Unit Size 042 through 070 (265/60/1),
(208/230/1) & (208/230/3)
Fan motors on unit sizes 042-070 in voltages 265/60/1,
208/230/1 and 208/230/3 (Figure 22) all have a five-
position terminal block. In order to change between high
and low speed, interchange the wires on the black and
red terminals.
Figure 22: Sizes 042-070 (265/60/1), (208/230/1) (208/230/3)
IM 930-6 • Enfinity Vertical Water Source Heat Pumps
Unit Size 024 through 036 (208/230/3)
Fan motors on unit sizes 024-036 in voltages 208/230/3
(Figure 23) all have a four-position terminal block.
In order to change between high and low speed,
interchange the wires on the black and red terminals.
Figure 23: Sizes 024-036 (208/230/3)
Notes: All motors have a wiring label that is keyed for
proper wiring operation. Check unit wiring dia-
gram (on electrical access panel) for proper unit
operation. Not all labels are the same.
Units leaving the factory are wired for high or low
fan speed (see Table 13 on page
speed settings).
Label is located on the back of the terminal block.
(Optional) ECM Motor
The ECM motor will maintain the rated airflow as static
pressure increases or decreases within the unit's
operating range. Contact the factory at 315-253-2771 or
800-432-1342 if an alternate airflow setting is required.
22
P t s -
rior o tart uP
21 for fan
www .DaikinApplied .com