Unpacking & Assembly - AR Blue Clean AR112S Instruction Manual

U & a
nPacking
• After unpacking the BLUE CLEAN POWER WASHER, lay out parts and accessories. Familiarize
yourself with the parts in the package by comparing them to those listed on the "PACKAGE
CONTENTS" page.
• The BLUE CLEAN POWER WASHER requires some minor assembly. You'll need a Phillips
screwdriver to install the handle to the main unit.
NOTE: Some parts may or may not be already assembled.
• Install the handle to the BLUE CLEAN POWER WASHER (Fig. 1). Place the screws in the holes
provided on the BLUE CLEAN POWER WASHER and handle, screw them together. Do not use
a power screwdriver. When the screw is completely tight, give a small final clockwise twist of the
screwdriver. Do not over tighten.
• Slide the (spray gun holder) onto the left side of the washer when facing it. This does not require
any screws. (Fig. 2)
• Slide (cord hook holder) onto the right side of the washer when facing it. This does not require any
screws. (Fig. 3)
8
SSembLy
OFF/O
ON/I
Fig. 2
Fig. 1
OFF/O
ON/I
Fig. 3