Table of Contents
Advertisement
Lock Settings
Set door unlock timer
Set Access Code to toggle
[open/close]
Set Access Code to toggle
[open/close] (partial
entry)
Safety Settings
Default safety setting
Extended safety settings
Disable all safety settings
Sound Settings
All sounds - On
All sounds - Off
Access sound - 1 second
buzz
Access sound - 2 short
beeps
Auto/Manual Code Entry Settings
Auto Code Entry Mode
Manual Code Entry Mode
Flashing Yellow LED Settings
Flashing Yellow LED - On
Flashing Yellow LED - Off
Access Lock (Optional)
Set Authorization Code
(Single User Mode)
Set Authorization Code
(Multi-User Mode)
Set Access Lock timer
Set Authorization Code to
toggle [on/off]
40 Seconds: 1-999 #
41 #
42 #
70 #
72 Number of false entries: 5-10 #
7600 #
831 #
830 #
811 #
810 #
821 #
820 #
841 #
840 #
2 4-digit code #
2 User number: 0 to 9
4-8 digit code #
50 Seconds: 1-999 #
51 #
Set the amount of seconds the device will
grant access before locking again.
Entering Access Code will toggle the lock
to stay open. Entering the Access Code
again will toggle back to lock.
Entering [The first 2 digits of an access
code, #] will toggle lock to remain open
and entering the full access code will
toggle back to close.
After 10 successive false codes, the keypad
is disabled for 30 seconds
After [5-10] successive false code entries,
the keypad is disabled for 15 minutes or
until the Master Code is entered.
All sounds will be activated
All sounds will be disabled
Upon unlocking, the keypad will signal
granted access with a 1-second buzz
Upon unlocking, the keypad will signal
granted access with 2 short beeps
The # key after entering an access code
will NOT be required.
Important Note: For this feature to work
with Multi-User Mode, the Master Code
and Access Codes must be the same
number of digits. Ex. If the Master Code is
6-digits, then the Access Codes must also
be 6-digits to have the Auto Code Entry
Mode to work.
The # key after entering an access code
will be required
The Yellow LED will blink every 2 seconds
during functionality
The Yellow LED will not blink during
functionality
Set 4-digit code for Access Lock activation.
Set 4-8 digit code for Access Lock
activation.
Set the amount of seconds Access Lock
will activate before deactivating
Entering Authorization Code will toggle
Access Lock on. Entering the Authorization
Code again will toggle Access Lock off.
Advertisement
Table of Contents
