Epson EPL-5900 Service Manual page 6

4.Handle the power cord with care and never use a multiple outlet.
Do not break, crush or otherwise damage the power cord.
Placing a heavy object on the power cord, or pulling or
bending it may damage it, resulting in a possible fire or
electric shock.
Do not use a multiple outlet to which any other appliance or
machine is connected.
Be sure the power outlet meets or exceeds the specified
capacity.
5.Be careful with the high-voltage parts.
A part marked with the symbol shown on the left carries a
high voltage. Touching it could result in an electric shock or
burn. Be sure to unplug the power cord before servicing this
part or the parts near it.
6.Do not work with wet hands.
Do not unplug or plug in the power cord, or perform any kind
of service or inspection with wet hands. Doing so could
result in an electric shock.
7.Do not touch a high-temperature part.
A part marked with the symbol shown on the left and other
parts such as the exposure lamp and fusing roller can be
very hot while the machine is energized. Touching them
may result in a burn.
Wait until these parts have cooled down before replacing
them or any surrounding parts.
8.Maintain a grounded connection at all times.
(This item may not apply in the USA.)
Be sure to connect the ground wire to the ground terminal
even when performing an inspection or repair. Without
proper grounding, electrical leakage could result in an
electric shock or fire.
Never connect the ground wire to a gas pipe, water pipe,
telephone ground wire, or a lightning conductor.
9.Do not remodel the product.
Modifying this product in a manner not authorized by the
manufacturer may result in a fire or electric shock. If this
product uses a laser, laser beam leakage may cause eye
damage or blindness.
10.Restore all parts and harnesses to their original positions.
To promote safety and prevent product damage, make sure
the harnesses are returned to their original positions and
properly secured in their clamps and saddles in order to
avoid hot parts, high-voltage parts, sharp edges, or being
crushed.
To promote safety, make sure that all tubing and other
insulating materials are returned to their original positions.
Make sure that floating components mounted on the circuit
boards are at their correct distance and position off the
boards.