Cannot Print Over A Network; Cannot Connect The Printer To The Network - Canon imagePROGRAF iPF6000S User Manual

Cannot print over a network

Cannot connect the printer to the network

Cause
The Ethernet cable is not connected
correctly to the printer's Ethernet port.
Downloaded from ManualsPrinter.com Manuals
Corrective Action
1.
Make sure the printer is connected to the network with the correct
Ethernet cable, and then turn the printer on. For instructions on
connecting the cable, refer to the Quick Start Guide.
2.
Make sure the Link indicator is lit.
The Link indicator is green if the printer is connected via 100
Base-TX and orange if connected via 10Base-T.
If the Link indicator is not lit, check the following points.
•
Make sure the hub is on.
•
Make sure the end of the Ethernet cable is connected
correctly.
Insert the Ethernet cable until it clicks and locks in place.
•
Make sure there is no problem with the Ethernet cable.
If there is any problem, replace the Ethernet cable.
•
Check the communication mode with the hub.
Although the printer normally detects the hub
communication mode and transmission rate automatically
(in auto negotiation mode), sometimes the hub settings
cannot be detected. In this case, congure the connection
method manually, specifying the communication mode in
use.
(→P.674)
Cannot print over a network
Troubleshooting 673