Maintenance; Cleaning The Scanner; Cleaning The Separator Module - Kodak i250 User Manual

Maintenance

Cleaning the Scanner

Cleaning the
Separator Module
A-61167 September 2002
The scanner will collect dust and other debris during routine scanning. Follow
the procedures in this section and clean the scanner at least once per week.
Clean the scanner and paper path daily if you are scanning carbonless paper
or newsprint, or if you are using the imprinter.
NOTES: Some debris from the rubber tires on the feed module and separator
module is normal. Tire debris does not always mean that the tires
are worn or damaged. After cleaning, inspect the tires for wear and
replace the separator module or feed module if necessary.
Staples and paper clips in documents may damage the scanner.
Remove all staples and paper clips before scanning.
There are two wear parts that you may replace: the feed module and the
separator module.
NOTE: To order cleaning supplies or replacement parts, refer to Appendix B,
Supplies and Accessories.
For best scanner performance, clean the feed module rollers, separator
module rollers, imaging guides, transport area, and paper path at least once
per week. Use only these cleaning materials:
• Kodak Digital Science Roller Cleaning Pads (Catalog No. 853-5981)
• Staticide Wipes for KODAK Scanners (Catalog No. 896-5519)
• Kodak Digital Science Transport Cleaning Sheets (Catalog No. 169-0783)
Use of any other cleaning materials could damage your scanner. In addition to
the recommended cleaning supplies, you may use a vacuum cleaner to
remove debris from the scanner.
1. Power down the scanner.
2. Remove any documents from the feeder area.
3. Lift up the scanner door release to unlatch the scanner door.
4. Pull up to open the scanner door.
19