Table Of Contents - Phase Linear UCD300 Owner's Manual

Am/fm/cd receiver
Table of Contents

Advertisement

UCD300/UMP400
Para obtener instrucciones en Espanol, dirijase a la pagina 20.
Pour des instructions en Francais,
referez-vous a
la page 38.
PREPARATION
Getting Started
It's a good idea to read all of the instructions
before beginning the installation.
Contents
Installation Instructions...................
.,' 3
............... ....................
. ... 5
.. 6
Operating Instructions ..................
. ..... 7
. ... 11
CD Changer Controls ............................ 14
Remote Control..... .................
..15
Care and Maintenance ........................ 16
Specifications ........... ......................
. ... 17
. .. 18
Installation Requirements
This unit is designed for installation in cars,
trucks and vans with an existing radio opening.
In many cases, a special installation kit will be
required to mount the radio to the dashboard.
These kits are available at electronics supply
stores and car stereo specialty shops. Always
check the kit application before purchasing to
make sure the kit works with your vehicle. If you
need a kit but cannot locate one, call our
customer support line at 1-800-323-4815.
(U.S.A. and Canada only,)
Tools and Supplies
The following tools and supplies are needed to
install the radio.
Torx type, ftathead and Philips
screwdrivers
Wire cutters and strippers
Tools to remove existing radio
(screwdriver, socket wrench set or other
tools)
Electrical tape
Crimping tool
Volt
meterltest
light
Crimp connections
18 gauge wire for power connections
16-18 gauge speaker wire
Speaker Requirements
Only connect speakers rated with a load
impedance of 4 ohms. Speakers with a load
impedance of less than 4 ohms could damage
the unit.
2
Disconnect Battery
Before you begin, disconnect the battery
negative terminal.
------------
Toll-Free Installation Assistance
If you require assistance, contact Technical
Support at 1-800-323-4815 from 8:30 a.m. to
7:00 p.m. EST Monday through Friday and from
9:00 a.m. to 5:00 p.m. EST on Saturday.
(U.S.A. and Canada only.)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the UCD300 and is the answer not in the manual?

This manual is also suitable for:

Ump400

Table of Contents