Extron electronics eLink 100 User Manual page 27

Problem Actions
IR remote control Ensure that the clear plastic film covering the battery contacts is
malfunctions removed before using the IR remote.
Ensure that the remote control batteries are fully charged.
Ensure that there is enough distance between the receiver
IR sensor and any fluorescent lighting or radiation that could
interfere with the IR signals.
A Searching... The eLink 100 can take up to 60 seconds to establish a wireless
link. If the link is not established within that time, verify that
message displays,
and the Link LED the transmitter is powered on and not connected to another
receiver.
blinks continuously.
The message Check the HDMI connection between the transmitter and the
Connected to video source.
source name,
please check
video source is
displayed.
A connection failure If more than one registered transmitter is present and the
message appears, receiver fails to connect to a transmitter within one to two
followed by the
minutes, the receiver goes into standby mode and shuts down
message Wireless the radio frequency. To connect to the desired source, press the
Off. Source button on the remote control and select the desired
source from the OSD menu.
The Link LED blinks Cycle power to the unit. If the problem persists, contact the
rapidly and there
Extron S3 Sales and Technical Support Hotline.
is no video on the
Power cycle the receiver and transmitter units. You may also
display.
reset the transmitter using the Reset button (see
A link cannot be Decrease the distance between the transmitter and receiver and
established, or audio remove any obstacles between them.
or video quality is
poor.
This message may appear during registration process. If this
The message Please
message appears for more than 60 seconds, cycle power on
wait, this action
both units, then restart the registration process.
may take up to
60 sec" appears
Power cycle the receiver and transmitter units. You may also
for more than 60
seconds.
reset the transmitter using the Reset button (see
eLink 100 HDMI Transmitter and Receiver • Reference Information
on page 8)
E
on page 8)
E
21