Extron electronics eLink 100 User Manual page 20

Unregistering a transmitter
To unregister a transmitter (remove a video source) from a receiver:
1. Power on the receiver.
2. From the Setup menu, select
menu.
to Remove
NOTE: Alternatively, you may press the Delete button on the remote control to
access this menu.
3. From the
Choose Source to Remove
unregistered.
Choose Source to Remove
EXTRON105
Figure 11. Choose Source to Remove OSD Menu
4. The message
Removing transmitter name. Press OK to continue or Exit to
Cancel is displayed.
removal procedure, press the Exit button.)
NOTE: While the transmitter is being unregistered, the message
transmitter name...
closes, indicating the source has been removed and the transmitter unregistered.
Modifying a video source name
To change the name of a video source:
1. Press the Menu button on the remote control to display the
2.
From the menu, select
Setup
3. From the
Choose Source to Rename
Rename Video Source Name screen appears, displaying only the name to be
changed.
4. Use the right and left arrow buttons on the remote control to move focus to the first
character that you want to change.
5. Press the up or down arrow buttons repeatedly until the desired replacement letter or
number is displayed.
To step through the alphabet in ascending (A-to-Z) order, use the up arrow. The
•
down arrow moves through the alphabet in descending (Z-to-A) order.
When you scroll through the characters in ascending order, the OSD displays the
•
letters of the uppercase alphabet, followed by the lowercase alphabet, then a
space, then digits
0
with the uppercase letters. In descending order, this sequence is reversed.
6. Press the OK button. The
7. Select a source from the menu to display or press the Exit button to close the OSD.
Remove Video Source
menu, select the name of the source to be
Press the OK button again to delete the source. (To stop the
is displayed. After approximately 30 seconds, the OSD
Modify Video Source Name
menu, select the source to be renamed. The
through , after which the display cycles back through, starting
9
menu is displayed.
Select a Video Source
eLink 100 HDMI Transmitter and Receiver • Operation
. This opens the
Choose Source
Removing
menu.
Setup
.
14